• Low profile ... just 2" (5 cm) above the tank!
  • Ideal where overhead obstacles are present
  • Flow rate of 2500 Gallons per Hour (9500 LPH)
  • Built in several lengths for many tank configurations
  • An alternative to air or mechanical agitation
In addition to our standard BXL2500 with over-the-side motor, this unit is available with Optional Long Motor Base to accommodate tank mounting surfaces up to 6-1/2" (16 cm) wide! Also see our larger low-profile model - the 5,000-gallon-per-hour BXL5000.


The BXL2500 filter system is shipped complete, ready to operate, with the following accessories:

1. Double cartridge holder

2. 45 Deg. elbow

3. 3" (8 cm) outlet extension

4. Two 15" (38 cm) Permacore Magnum reusable filter cartridges with Loading Slats & two Filter Plugs

5. Adjustable tank clamp

The BXL2500 is designed for tanks where overhead clearance is limited. The motor is inverted and positioned outside the tank, taking up only 2" (5 cm) of space above the tank. The unit provides a maximum flow rate of 2500 gallons per hour. Use it stationary on one tank or move it from tank to tank. Multiple body lengths (8", 10", 12", and 14") enable use of the BXL2500 in tanks with varying solution levels and depths.

The BXL2500 comes ready to operate and includes the items shown in the labeled photograph below. For best results in most metal finishing solutions, use the BXL2500 with our FK50 Poly-Spun disposable filter cartridges in the appropriate length.

Important!
To ensure proper priming, solution must always be above Weep Hole on pump body. Specify length of pump body when ordering.
Unit of Measure

Specifications

Pump Materials of Construction

N/A CPVC

Shaft Material

N/A PTFE-covered 303 stainless-steel (Standard)
Flow Rate1 N/A 2500 gallons per hour (9500 liters per hour) at 60 Hz

Pressure

N/A 27 feet (8.2 meters) of head pressure

Motor Rating

N/A 120 V, 6.0 A, 50/60 Hz, 2850 rpm 240 V, 3.0 A, 50/60 Hz, 3450 rpm

Motor Power

N/A 1/3 hp250 W

Motor Features

N/A Epoxy coated, TEFC, Thermally Protected

Phase

N/A Single

Dimension A

N/A 12-3/4 "32 cm

Other Options

N/A Optional Long Motor Base ($80.00)To accommodate tank mounting surfaces up to 6-1/2" (16 cm) wide!

Optional - Filter Holder

N/A NFH10 Nut-Style, 10" Length ($28.00)NFH15 Nut-Style, 15" Length ($35.00)NFH20 Nut-Style, 20" Length ($38.00)Note: Nut-Style Filter Holder results in a flow-rate reduction of 10%
Weight2 N/A 25.0 lbs11.0 kg

Note

Note3
N/A Running Pump Dry Does Not Damage Motor, Pump, Seals or Bearings

The Nut-Style Filter Holder allows you to change filter cartridges without loosening the Filter Screws on the Flo King pump. Just unscrew Threaded Nut from bottom of Stem, remove old cartridge, install new cartridge, tighten Nut and resume filtration.
  • 1 A flow-rate reduction of 18%(±3%) is typical when operated at 50 Hz.
  • 2 About 25 pounds (11 kg) in CPVC, depending on pump body length
  • 3