Metafin Supply Co.
Metafin Supply Co.
26575 W. Commerce Drive, Unit 504 Volo, IL 600739659

Phone: 8477401599
Fax: 8477401930
Email: sales@metafinsupply.com
Print Back
Sold in case quantities only

ELPC Series Electroplating Carbon Cartridges
  • Cellulose-free construction
  • Resistant to chemical breakdown in both acidic and alkaline solutions up to 180ºF (82ºC)
  • Will not contribute to plating porosity or brittleness
  • Integrated post-filtration layer to ensure that no carbon fines are bled into the plating bath
  • End cap gaskets are permanently molded on to the end caps to ease filter cartridge change-out (gaskets cannot fall off into the filter housing during installation or removal of filter)
The ELPC Series is a premium line of activated carbon filter cartridges specifically designed for electroplating solutions. They represent the best technology available in cartridge filtration for use in a wide range of electroplating applications.

The unique technology used to manufacture this product ensures that there is no bleeding of carbon fines into the plating bath. In addition, the carbon that is used is an ultra-clean, highly purified carbon to ensure that sulfur is not leached into the plating bath.

Pentek ELPC Series products have a 7 micron nominal rating with superior dirt-holding ability.

The fibrous physical structure created by our proprietary Fibredyne technology produces a unique block with true depth filtration capability which allows for maximum treatment with minimal pressure drop through the cartridge.

See downloads for Brochure
Unit of Measure

Specifications

Max. Dimensions

 N/A 2-7/8 x 20 "

Case Quantity

 N/A 20

Weight per Case

 N/A 24 lbs

Micron Rating (Nominal)

 N/A 10

Intial ΔP (psi) @ Flow Rate (gpm)

 N/A 0.2 bar @ 7.6 Lpm 3.4 psi @ 2 gpm

Temperature Rating

 N/A 40 to 180 ºF

Materials of Contruction

 N/A End Caps - Polypropylene Filter Media - Bonded PAC Gaskets - Santoprene™ Netting - Polyethylene

Manufacturer

 N/A Pentair

Warning

 N/A Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the unit.

Note

Note1 N/A Cartridges will contain a very small amount of carbon fines (very fine black powder). After installation, a new cartridge should be flushed with sufficient water to remove all traces of fines prior to using the water.

Micron ratings based on 85% or greater removal of given particle size. Estimated capacity using 2ppm free available chlorine at 0.5 ppm breakthrough.
  • 1