Sold in case quantities only

ELPC Series Electroplating Carbon Cartridges
  • Cellulose-free construction
  • Resistant to chemical breakdown in both acidic and alkaline solutions up to 180ºF (82ºC)
  • Will not contribute to plating porosity or brittleness
  • Integrated post-filtration layer to ensure that no carbon fines are bled into the plating bath
  • End cap gaskets are permanently molded on to the end caps to ease filter cartridge change-out (gaskets cannot fall off into the filter housing during installation
  • more
Unit of Measure

Specifications

Max. Dimensions

2-7/8 x 30 "

Case Quantity

20

Weight per Case

35 lbs

Micron Rating (Nominal)

10

Intial ΔP (psi) @ Flow Rate (gpm)

0.2 bar @ 11.4 Lpm 3.4 psi @ 3 gpm

Temperature Rating

40 to 180 ºF

Materials of Contruction

End Caps - Polypropylene Filter Media - Bonded PAC Gaskets - Santoprene™ Netting - Polyethylene

Manufacturer

Pentair

Warning

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the unit.

Note

Note1
Cartridges will contain a very small amount of carbon fines (very fine black powder). After installation, a new cartridge should be flushed with sufficient water to remove all traces of fines prior to using the water.

Micron ratings based on 85% or greater removal of given particle size. Estimated capacity using 2ppm free available chlorine at 0.5 ppm breakthrough.
  • 1