Precoated Flow Rate (Filtering Capacity) |
N/A 13,000 gph |
Open Pumping Capacity |
N/A 14,400 gph |
Filtration Surface Area |
N/A 124 ft² |
Number of Filter Media |
N/A 70 |
Filter Media Diameter |
N/A 19 " |
Sludge Holding Capacity |
N/A 5.94 ft³ |
Length |
N/A 90 " |
Width |
N/A 55 " |
Height |
N/A 55 " |
Hose Connections Suction Discharge |
N/A 2 "2-1/2 " |
Hose Length (Suction and Discharge) |
N/A 10 ft (Two of Each) |
| Motor1 | N/A 5 HP TEFC (Two Motors) |
Pump Options |
N/A CRS Pump with Mechanical Seal - Standard PPM - Magnetic End Suction Pump- Adder PPQ - Magnetic Self-Priming Pump - Adder |
Slurry Tank Option |
N/A WITH SLURRY TANK - Standard |
Weight |
N/A 1900 lbs |
Manufacturer |
N/A Mefiag |
Features |
N/A
|
Filter |
N/A
Filter chambers are constructed of mild steel with hard rubber lining (3 mm) on the interior and corrosion resistant paint (2 coats) on the exterior. A flanged tangential inlet is standard, along with a bottom outlet and drain. Stainless steel eyebolts with handwheels hold the powder coated steel cover in place. The lifting device provides for mechanical movement of the cover for maintenance purposes. A pressure gauge (0-60 PSI) is supplied with a corrosion resistant guard. Filter media suited for the application is placed between the rigid polypropylene filter discs. Filter media of various materials and micron ratings are available. Ten (10) micron cellulose is standard. All systems are mounted on a powder coated structural steel frame with casters for easy handling. |
Pump |
N/A Polypropylene centrifugal pumps are equipped with TEFC, flange mounted motors. Mechanical seal is MEFIAG CRS-25/B with silicon carbide faces. Pump shaft is stainless steel. The motor starter is mounted in corrosion resistant, water tight NEMA 4 enclosure. The 15,000-LS Series, Fybroc fiberglass centrifugal pumps are standard. Mechanical seal options are single CRS- 35/B with silicon carbide faces or double water flush. |
Slurry Tank Specifications |
N/A Slurry tanks are mild steel construction with an interior of hard rubber (3 mm) and an exterior of corrosion resistant paint (2 coats). They are used to facilitate pre-coating and addition of activated carbon (if required), as well as solution make-up and priming of the pump. The slurry tank can also be used to store solution from the filter chamber during changing of media or maintenance.Pre-coating provides superior filtration and extends the lifeof the filter media. |
Piping, Valves and Connections |
N/A Piping, valves, and connections are all CPVC construction. Suction of the pump is piped to permit flow from the solution tank, slurry tank, and the filter chamber. |
